Fat Bob's Garage - 1994 / Ford / Ranger / All Products

Ford Explorer/Ranger Steering Stabilizer 1991-1997

Wed, 29 May 2013 09:17:00 GMT

Ford Explorer/Ranger Steering Stabilizer 1991-1997
Buy Now: $69.95

Ford Explorer/Ranger Steering Stabilizer 1991-1997

With the installation of all lift kits and larger tires it is important to check the condition of your steering stabilizer. If the stabilizer is worn or is leaking it should be replaced.

Steering stabilizers are designed to restrain "bump steering" and front end vibration, giving added life to tires, ball joints, and other steering components. A multiple stabilizer kit is recommended for vehicles equipped with a snow plow, winch, or 35" tires and above.

Limited Lifetime Warranty
White powder coat finish
Improves tire and ball joint wear
Poly-urethane bushings for long life
Chromed hardened 9/16" piston rod
Improves control and handling for oversize tires

Vehicle Application:
1991-1994 Ford Explorer
1991-1997 Ford Ranger

***This product is not discountable***

Visit Ranger to see additional products in this category.

Ford Ranger/Bronco II/Explorer 1.5" Leveling Suspension 4WD 1983-1997

Fri, 7 Dec 2012 06:20:00 GMT

Ford Ranger/Bronco II/Explorer 1.5" Leveling Suspension 4WD 1983-1997
Buy Now: $119.95

Ford Ranger/Bronco II/Explorer 1.5" Leveling Suspension 1983-1997

Kit contains: Front lifted coil springs.

Benefits:
Increased ground clearance.
Levels the front of the vehicle with the rear.
100% simple bolt on installation

Estimated Install Time: 1-3 hours
Wheel Backspacing: Factory

Vehicle Application:
1983-1997 Ford Ranger 4WD
1984-1990 Ford Bronco II 4WD
1990-1994 Ford Explorer 4WD

***This product is not discountable***

Visit Ranger to see additional products in this category.

Short Add-A-Leaf Spring Lift Kit

Fri, 29 Jun 2012 13:04:00 GMT

Short Add-A-Leaf Spring Lift Kit
Buy Now: $79.95

Short Add-A-Leaf Spring Lift Kit

This pair ofrear Add-A-Leafs will lift the back of your vehicle 1.5” –2"
Kit contains2 Add-a-Leafs 20", center bolts, and installation instructions.

Installation Instructions

Visit Ranger to see additional products in this category.

Ford Ranger 2" Front Spacer Leveling Kit w/Extender Studs 4WD 1983-1997

Tue, 18 May 2010 11:28:00 GMT

Ford Ranger 2" Front Spacer Leveling Kit w/Extender Studs 4WD 1983-1997
Buy Now: $59.95

Ford Ranger 2" Front Spacer Lift Leveling Kit (w/ Extender Studs) 4WD 1983-1997

These polyurethane spacers will fit underneath your coil springs, and the stud extender lengthens the bolt that goes from underneath the coil seat to the top of the spacer.

Vehicle Application:
1983 - 1997 Ford Ranger 4WD

Kit contains:
Two (2) spacers, two (2) 5/8” stud extenders, and installation instructions.

Note: Truck will need after-market camber eccentric to be aligned properly. Camber eccentrics are available through most alignment shops.

Installation Instructions - PDF Download

Visit Ranger to see additional products in this category.

Ford Ranger 2WD/4WD Add-A-Leaf Spring Kit 1983-2012

Tue, 23 Mar 2010 11:03:00 GMT

Ford Ranger 2WD/4WD Add-A-Leaf Spring Kit 1983-2012
Buy Now: $79.95

Ford Add-A-Leaf Spring Lift Kit for various 2.5 Inch Wide Leaf Spring models ranging in year from 1972-2008.
Ford Add-A-Leaf Rear Spring Lift Kit - Lifts the back end of your vehicle 1.5" - 2.5". (2" Average)

Vehicle Application:
1983-2012 Ford Ranger 2WD/4WD
1990-2012 Ford Ranger 2WD

Installation Instructions

Visit Ranger to see additional products in this category.

Ford Ranger Pitman Arm 1983-1997

Thu, 4 Mar 2010 11:59:00 GMT

Ford Ranger Pitman Arm 1983-1997
Buy Now: $60.95

Zone Offroad Ford Ranger Pitman Arm 1983-1997

We know the importance of getting your steering geometry setup correctly when adding a lift. These heavy duty 1 piece forged pitman arms will reduce the drag link angle to improve your handling when used to match the angle of your track bar.

Vehicle Application:
1983-1997 Ford Ranger

Installation Instructions - PDF Download

Visit Ranger to see additional products in this category.

Ford Ranger Rear Add-a-Leaf Lift Kit 4WD/2WD 1983-2012

Mon, 23 Nov 2009 16:25:00 GMT

Ford Ranger Rear Add-a-Leaf Lift Kit 4WD/2WD 1983-2012
Buy Now: $124.95

Ford Ranger Rear Add-a-Leaf Lift Kit 4WD/2WD 1983-2012

This Add-A-Leaf kit will raise the rear of your vehicle by an average of 2".
(Actual lift height depends on the condition of your leaf pack.)
Add-A-Leaf spring lift kits are great for towing or hauling.
The Add-A-Leaf increases your load capacity and compensates for added weight in the rear of the truck, reducing rear end sag during towing or hauling.
The springs measure about 31" long and are designed for use in 2.5" wide leaf packs.
Adds 900-1000 LBS weight capacity.
Made in USA
Kit Contains: 2 Add-a-Leaf Springs, 2 Center pins

Vehicle Application:
Ford Ranger 1983-2012 4WD/2WD

Instructions Installation PDF Download

Visit Ranger to see additional products in this category.

Ford Bronco/Ranger II Stabilizer Mounting Kit 1983-1997

Tue, 27 Oct 2009 16:28:00 GMT

Ford Bronco/Ranger II Stabilizer Mounting Kit 1983-1997
Buy Now: $47.94

BDS Stabilizer Mounting Kit

Heavy-duty gusseted construction
Yellow zinc plating for long life
All hardware and instructions included

Notes:
This dual stabilizer is a stacked design (over/under).
This system will not work on stock height vehicles.
This system will not work on vehicles equipped with a factory front sway bar.

Vehicle Application:
1983-1990 Ford Bronco II 4WD
1983-1997 Ford Ranger 4WD

Installation Instructions - PDF Download

Visit Ranger to see additional products in this category.

Ford Stabilizer Mounting Kit 1980-1997

Tue, 27 Oct 2009 16:28:00 GMT

Ford Stabilizer Mounting Kit 1980-1997
Buy Now: $48.35

BDS Stabilizer Mounting Kit

Heavy-duty gusseted construction
Yellow zinc plating for long life
All hardware and instructions included

Vehicle Application:
1980-1996 Ford Bronco 4WD w/out Factory Dual Shocks
1983-1990 Ford Bronco II 4WD
1990-1994 Ford Explorer
1980-1996 Ford F150 4WD w/out Factory Dual Shocks
1980-1996 Ford F250 Excluding Monobeam
1980-1996 Ford F350 Excluding Monobeam
1983-1997 Ford Ranger 4WD

Installation Instructions - PDF Download

Visit Ranger to see additional products in this category.

Ford Ranger 4" Coil Kit Pro-Ride Coil Kit (Pair) 1983-1997

Tue, 27 Oct 2009 16:10:00 GMT

Ford Ranger 4" Coil Kit Pro-Ride Coil Kit (Pair) 1983-1997
Buy Now: $179.25

Ford Ranger 4" Coil Kit Pro-Ride Coil Kit (Pair) 1983-1997

BDS Pro-Ride coil springs are designed to withstand full coil bind and bounce right back to their original height. In other words, you won't have to worry about sagging springs. All BDS coils are shot peened to increase tensile as well as hydraulically pre-set to reduce long term fatigue. The polyester based powder coating flexes with the springs to ensure long term protection.

Shot peened for increased tensile strength

Hydraulic pre-set for reduce fatigue

Polyester based powder coating

Designed to withstand coil bind

Springs are sold in pairs

Vehicle Application:
1984-1990 Ford Bronco II 4WD
1983-1997 Ford Ranger 4WD

Installation Instructions - PDF Download

Visit Ranger to see additional products in this category.